Tag Archives: InfoWorks CS

Berlin Waterworks Used InfoWorks to Formulate Recommendations for the Operation, Expansion and Adjustment of Future Urban Wastewater and Stormwater Infrastructures

Posted on November 4, 2016 by Blog Adminstrator

In view of existing and future challenges, such as the results of climate change and the changing manner of water usage, the overriding target of the joint research project KURAS (Concept for urban stormwater management and wastewater systems), sponsored by … Continue reading →

Posted in InfoWorks CS | Tagged , , , , , | Comments Off on Berlin Waterworks Used InfoWorks to Formulate Recommendations for the Operation, Expansion and Adjustment of Future Urban Wastewater and Stormwater Infrastructures

Retirement of InfoWorks CS is now complete

Posted on January 13, 2016 by Andrew Walker

The formal announcement of the retirement of InfoWorks CS was made on the 1st December 2014, following the successful introduction of InfoWorks ICM SE (Sewer Edition) in 2013. Press Release: Innovyze Retires InfoWorks CS with Launch of More Powerful Next-Generation … Continue reading →

Posted in InfoWorks CS, InfoWorks ICM, Updates | Tagged , , | Comments Off on Retirement of InfoWorks CS is now complete

Surcharge State

Posted on December 1, 2015 by Raana Tohid

There have several questions relating to surcharge state recently. The information below shows how the values are calculated. The software calculates the surcharge state based on the following methodology. <1 – Water is below the soffit at both ends of … Continue reading →

Posted in InfoWorks CS, InfoWorks ICM | Tagged , , | Comments Off on Surcharge State

InfoWorks Simulations (32-bit vs. 64-bit)

Posted on July 13, 2015 by Andrew Walker

InfoWorks CS is a pure 32-bit application. InfoWorks ICM is available in both 32-bit and 64-bit editions. It’s a very common misconception that 64-bit applications are a lot faster than 32-bit ones.  That is not the case in general, and … Continue reading →

Posted in InfoWorks CS, InfoWorks ICM | Tagged , | Comments Off on InfoWorks Simulations (32-bit vs. 64-bit)

Creating a TIN from XYZ manhole data

Posted on May 17, 2013 by Raana Tohid

InfoWorks supports the use of a TIN (triangular irregular network) ground model to represent the ground surface in the area covered by your model. Ground models provide a three dimensional view of the ground terrain. They require three pieces of … Continue reading →

Posted in InfoWorks CS, InfoWorks ICM | Tagged , | Comments Off on Creating a TIN from XYZ manhole data

Considerations when importing an InfoWorks CS model into InfoWorks ICM and vice-versa

Posted on February 1, 2013 by Andrew Walker

You need have no concerns when going from InfoWorks CS (or CS/2D) to InfoWorks ICM as there’s a 100% match in the approach used for building Stormwater and/or Wastewater models in InfoWorks CS and InfoWorks ICM.  A migration file is exported … Continue reading →

Posted in InfoWorks CS, InfoWorks ICM, InfoWorks RS | Tagged , , , , | Comments Off on Considerations when importing an InfoWorks CS model into InfoWorks ICM and vice-versa

The Three Things You Must Know About InfoWorks CS

Posted on November 19, 2012 by Mike Reeves

Very quickly, here are three things which can catch out even the most experienced of modellers. 1. In the simulation parameters you must have the “initialisation: tolerance for volume balance” and “simulation: tolerance for volume balance” both set to 0.01. This … Continue reading →

Posted in InfoWorks CS | Tagged , , , , , , | 1 Comment